--- Anahata wrote: On Wed, Oct 22, 2003 at 10:14:58PM -0500, Reuben Martin wrote: > First: Using an equalizer, kill all frequencies below ~600 and above > ~2k. Use a graphic EQ for this. (The two values are just examples, you > can play with both frequencies to get the desired sound you're looking > for.) > > Second: get a recording of the inside blank track that comes after the > last song of a noisy record. Loop this noise and mix it over top of > the song once you've done the band pass filter from step one. > That's a bit drastic for vinyl - more like an acoustically recorded 78rpm from about 1920. Those were pressed on shellac, not vinyl. The priciple's about the same, though - add a few random background ticks and clicks, a bit of white noise as many vinyl discs had tape noise from the master, possibly a bit of distortion on peaks if you want it to sound like a worn record/stylus, and also some gentle frequency variation at 0.5 Hz (for 33 1/3 rpm) to simulate a less-than perfect turntable or warped record. I'm sure it can be done with Linux tools... -- Anahata anahata@treewind.co.uk Tel: 01638 720444 http://www.treewind.co.uk Mob: 07976 263827 ------ I'd say its all possible with audacity: http://audacity.sourceforge.net Its an Multitrack-able Wave/Mp3/OGG-manipulation tool with LADSPA-support, I think. Anyway, there are a lot of "integrated plugins" that allows what you want to do. A real PROGRAMM can do what you want is not written, I think ... ;) Sascha Retzki _____________________________________________________________ Linux.Net -->Open Source to everyone Powered by Linare Corporation http://www.linare.com/