Hey all,<br><br>I&#39;m a bit overwhelmed when I mentally go through the possible ways of organising and syncing my midi maps in linuxsampler to Rosegarden/how many midi ports etc to use.<br><br>My situation is thus:<br>I have about 50 or so midi banks comprising of anywhere from 5 to 128 instruments, each in their own seperate midi map (Flame Guitars 1, 2, 3, General Midi Set etc) and each bank is numbered sequentially throughout the entire Map (as a side note, this probably isn&#39;t the most efficent way of doing this, but I&#39;m learning!).<br>
<br>Now, in Rosegarden, I&#39;ve set up Banks in the &#39;Manage Midi Devices&#39; tab for a single midi device (I have all 50 banks of the midi maps here, accessed by sending LSB Change messages to linuxsampler) and entered in each program name (By hand! I&#39;m going off on tangents left right and center here, but surely there&#39;s a more automated way of entering in Program names for changing patches?).<br>
<br>So, considering that Midi can only handle 16 channels at any one time for a single midi port, I&#39;m obviously going to have to use (currently) about 4 midi ports in linuxsampler if I want 1 midi bank on each channel (not necessarily going to be using all of them at the same time of course).<br>
<br>The question then is:<br>Should I take 16 midi banks in linuxsampler, and assign them to a single midi map, which&#39;ll then be assigned to 16 channels connected to a single midi port, accessible by Rosegarden or perhaps group them by instrument type in groups of 16 etc?<br>
<br>I would appreciate your views on this immensely!<br><br>Andrew.<br>