<div dir="ltr">I have an interesting problem.  I'm using optical outputs to a d/a with 8 output channels (Frontier Tango24), but I needed 10 output channels.  So for the l/r rear channels I'm using the spdif outputs from my RME card connected to an Orei DA21 2 channel D/A unit.  This seemed to work fine, but when testing I limited the Ecasound output to LFE only, and I noticed that somehow the LFE signal gets sent to the l/r rear amp in addition to the sub amp, and I hear LFE coming out of my small(er) rear speakers.  (I put a 50hz high-pass filter on them for now, until I figure this out.)  <div><br></div><div>I'm guessing this might have to do with 32 bit vs. 24 bit output or something.  Here's the line in Ecasound that outputs to Jack:</div><div><div>-a:rear,LFE,sub_left,sub_right,center_sub,center_low,center_mid,side_low,</div><div>side_high -f:f32_le,10,48000 -o:jack</div></div><div><br></div><div>Any ideas?</div><div>Thanks,</div><div>John</div><div><br></div><div><br></div></div>