[linux-audio-dev] Utility for recording audio track with midi clock

[Alfons Adriaensen]

On Thu, Jul 01, 2004 at 09:19:06AM -0400, Paul Davis wrote:

> getting a general purpose computer to output MIDI Clock (and/or MIDI
> Time Code, just so nobody confuses the two of them) is a very hard
> problem. There are 24 MIDI Clock messages per quarter note. This means
> that for a piece in 4/4 at 120bpm, you need to output 1 MIDI byte
> every 20ms. Not so bad - its a nice even multiplier of the system
> interrupt frequency. However, just change the tempo or the time
> signature, and all of a sudden you have situations where the MIDI
> Clock byte needs to be output every 18ms or every 32ms or ever 9.7ms
> or every 56.5ms. 

This by itself is not the main problem. Using a 1000 Hz RTC to schedule
MIDI output as suggested by Tim, this requires something similar to the
Bresenham algorithm. Assuming there are no further random delays, the timing
jitter will be +/- 0.5 ms, or 0.29 ms RMS. A well designed receiver, using
an adaptive bandwidth PLL or an adaptive open loop algorithm, should be
able to estimate instantenuous tempo to within say a percent relative
error and be able to follow tempo changes up to say 5 Hz. (based on some
quicky calculations).

The real problem is probably that most Midi clock receivers are not designed
to tolerate too much jitter.

-- 
FA