[linux-audio-user] Re:Ardour: trying to add a "bus" causes a crash?

[Sylvain Robitaille]

On Wed, 30 Aug 2006, Spencer Russell wrote:

> Do you have JACK set to playback only?

I did, yes, since I'm presently mixing already recorded tracks.

> If I recall, I had this problem with saved sessions. A new session
> would work, I think, but once I saved it and opened it again, I
> couldn't add a bus if JACK was set to playback only. If you set JACK
> to full duplex the problem should go away.

Indeed it did!  Thank you _very_ much!

> I guess not a lot of people run Ardour with JACK on playback only.

Could be.  Perhaps I don't need to change Jack's configuration based on
whether I'm tracking or mixing?  (I do have a few saved configurations,
for example, because some projects I'm working on were recorded by
others with a different sample rate than I normally like to work with,
and it's a lot easier, and sounds better at least on my system, to just
adjust Jack than it is to resample the tracks.)

Alright, then ... on with the mix!  :-)

-- 
----------------------------------------------------------------------
Sylvain Robitaille                              syl at alcor.concordia.ca

Major in Electroacoustic Studies                  Concordia University
Faculty of Fine Arts / Music Department       Montreal, Quebec, Canada
----------------------------------------------------------------------