[LAU] Recording help

[Michael Petersen]

I can't figure out how to record in any form.  I have a hammerfall 96/52
card. I also have an intel card on the board but I removed the module
(sudo modprobe -r snd_hda_intel) because I don't use it for anything on
Linux.  I am using the newest Ubuntu Studio and everything appears to
work except when I record I get no sound signal. I can play sound in
ardour, audacious, audacity, rezound, rtcmix using either native alsa or
jack. Please help me to figure this out. Here is the info for the card:

pmstudio at sphere:~/m/sounds$ cat /proc/asound/card0/rme9652 
RME Digi9652 (Rev 1.5) (Card #1)
Buffers: capture f6000000 playback f6200000
IRQ: 20 Registers bus: 0xfd000000 VM: 0xf88aa000
Control register: 4008

Latency: 1024 samples (2 periods of 4096 bytes)
Hardware pointer (frames): 0
Passthru: no
Clock mode: autosync
Pref. sync source: ADAT1

ADAT1 Input source: ADAT1 optical

IEC958 input: Coaxial
IEC958 output: Coaxial only
IEC958 quality: Consumer
IEC958 emphasis: off
IEC958 Dolby: off
IEC958 sample rate: error flag set

ADAT Sample rate: 44100Hz
ADAT1: No Lock
ADAT2: No Lock
ADAT3: No Lock

Timecode signal: no
Punch Status:

 1: off  2: off  3: off  4: off  5: off  6: off  7: off  8: off 
 9: off 10: off 11: off 12: off 13: off 14: off 15: off 16: off 
17: off 18: off 19: off 20: off 21: off 22: off 23: off 24: off 


Thanks, Mike