[LAU] BCF2000

[Jozef Henzl]

Dne pondělí 29 říjen 2007 15:03 Kevin Cosgrove napsal(a):
> Hi,
>
> A bit over a month ago my BCF2000 was working just fine.  I
> didn't have to do much special with it, just plug it in via USB,
> turn it on, and put it into "Logic Control" mode.  Then it would
> show up in /proc/asound as card3.  But, now it doesn't show up in
> /proc/asound.  No messages appear in /var/log/messages.  Where
> should I start to troubleshoot this?

Check the usb cable. Or you can reset it to the initial state, which AFAIK has 
usb connection turned on by default.
/var/log/messages or dmesg should show something like
usb 4-1: new low speed USB device using uhci_hcd and address 2
at least

-- 
Jozef Henzl
http://popcorp.org