[LAU] PCI conflict between my RME HDSP and other PCI

[moises acuna]

I've been trying to use my RME HDSP PCI  + Digiface, and do some
experimental DSP with Nallatech BenOne with an FPGA on it, but in Fedora
core 6, (because the DSP builder can only provide me with drivers for that)
but when I try to use both cards at the same time the system doesn't see the
HDSP, i can't load the firmware with the hdsploader app. nor using the mixer
or anything.

an extract of  results of the "lspci -vv" command are:

06:01.0 Co-processor: Xilinx Corporation Unknown device 4029
        Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping+ SERR- FastB2B-
        Status: Cap- 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
        Latency: 32
        Interrupt: pin A routed to IRQ 74
        Region 0: Memory at 70014000 (32-bit, non-prefetchable) [size=16K]

06:03.0 Multimedia audio controller: Xilinx Corporation RME Hammerfall DSP
(rev 35)
        Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
        Status: Cap- 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
        Latency: 32
        Interrupt: pin A routed to IRQ 185
        Region 0: Memory at 70000000 (32-bit, non-prefetchable) [size=64K]



Anyone ever had a problem similar to this one? . Thanks in advance for any
help.




-- 
Moisés AAC
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.linuxaudio.org/pipermail/linux-audio-user/attachments/20090330/f798086a/attachment.htm