[LAU] Questions on New Recording Gear

fons at kokkinizita.net fons at kokkinizita.net
Tue Jan 26 12:47:07 EST 2010


On Tue, Jan 26, 2010 at 10:05:05AM -0600, Ectropic Harmony wrote:

> Mics currently placed about 3 or 4 feet from sound sources.
> XLRs into mixer Ins on the strips.
> Phantom power enabled.
> Gains on strips are set to an uncomfortably high level (over half and
> it's still low).

There's nothing wrong with turning them up as high as necessary. 

> Main Mix & the channels' faders are all set to "U".
> Direct Outs from the back of the mixer into the Ins on the Delta 1010.
> Default button settings on back of Delta 1010 (buttons out, allowing "+4")
> Software connections via JACK
> Envy24 running, with levels maxed out (ins and outs).

Don't do that. As a starting point set all DAC/ADC levels
to 127 (that's max for the DACs but not for the ADCs).
Above 127 the ADCs have extra gain which you don't need
since your mixer will provide more than enough output level.
In the envy24 monitor mixer mute everything.
In the envy24 patchbay set all analog outputs to 'PCM'.

> Ardour (no current changes in Ardour's mixer's levels, using default).

There are two things to get right:

1. The input gains on the mixer (for mics and other
sources). Getting this right has nothing to do with
the Delta 1010 or the PC. Do this first, using the
mixer's meters and headphone monitoring. The mixer
has more than enough gain and control range to get
this right. 

2. The gains between your mixer and the digital world.
These are set with the envy24 DAC and ADC gains, see
higher. Once set never touch them again (since you can
do everything on the mixer), and only use Ardour's 
level meters. 

Ciao,

-- 
FA

O tu, che porte, correndo si ?
E guerra e morte !



More information about the Linux-audio-user mailing list