[LAU] Jack users - how many channels do you want with PA module-jackdbus-detect?

[Kaj Ailomaa]

On Thu, 28 Feb 2013 23:48:03 +0100, Fons Adriaensen <fons at linuxaudio.org>  
wrote:

> On Thu, Feb 28, 2013 at 02:30:32PM -0800, Len Ovens wrote:
>
>> No matter what pulse defaults to in channel numbers, it will always  
>> allow
>> configuring to as many channels as the device supports if the default is
>> not what the user wants.
>
> I hope it can be configured as well to just create its Jack ports and
> NOT connect them to whatever device Jack is using, leaving this to
> the user.
>
> This is required if any processing is done before the signal goes
> to the hardware (room correction or EQ, crossover filters, etc.).
> It is also required if PA is providing e.g. a telephone signal
> which probably should connect to a SW mixer and not directly to
> the HW output.
>
> Ciao,
>

It autoconnects, which I think is totally fine for most use cases.
In some cases one would of course like to configure that, just like with  
any application. There's no parameter for autoconnection yet, to my  
knowledge. Something one would like to be able to set for any jack  
applications in fact.