[LAU] Monitoring and effects (Ardour)
Robin Gareus
robin at gareus.org
Sat Jan 25 17:46:47 UTC 2014
On 01/25/2014 06:38 PM, Robin Gareus wrote:
> On 01/25/2014 06:29 PM, jonetsu at teksavvy.com wrote:
>> Hello all,
>>
>> I sit possible to monitor a to-be-recorded Ardour track without
>> actually recording it. By monitoring I mean hearing all effects that
>> are on that channel. What I currently do is to add a send on the track
>> that is sent to channel 8 (1010LT card). So then, channel 8 outputs
>> the instrument plus all effects applied to it (assuming the send is at
>> the end of the chain). But, it only works when recording is on. Not
>> so much of a problem, as the track can be deleted, although it could be
>> nice not to have to press record to hear the monitoring, just to
>> practice or fool around.
>>
>
> Ardour3 has dedicated buttons on the mixer-strip to choose what is
> monitored [DISK] vs [In]. If you have auto-input enabled they're
> toggled automatically when you roll the transport, but you can manually
> override for the track in question at any time.
>
> https://github.com/Ardour/ardour/raw/master/doc/monitor_modes.pdf
>
> There's also the possibility to simply use the monitoring section and
> PFL (Post Fader Listen Solo).
>
OOPS. AFL for "After Fader"; PFL would be "Pre Fader". :)
(it can be further configured in Edit > Prefernces > Solo/Mute)
anyway, given that you want it on a dedicated port,
Session > Properties > Monitoring > Use Monitoring Section
is probably what you want.
ciao,
robin
More information about the Linux-audio-user
mailing list