[LAU] ShowQ - "a QLAB for Linux"

Peter P. peterparker at fastmail.com
Thu Aug 10 22:05:15 UTC 2017


Hi,

* Tim <termtech at rogers.com> [2017-08-10 20:51]:
[...] 
> So, are you saying that ShowQ actually runs, then shows
>  the error message some time later after usage, or
>  right away upon starting it shows that message box?
It shows the message box right away at startup, then, upon confirming
that message box, showq exits.
 
> Here I am able to run ShowQ and I created a wave-file cue and
>  was able to preview (listen to) it no problem.
Thank you, I never got so far.
 
> I also created a midi patch in the patch section, and
>  it connected to my midi ports no problem.
> 
> I can tell by the listed port names that it uses
>  ALSA for midi, not Jack midi.
> 
> Some quirks though: The wave preview worked fine the first time,
>  but upon restarting ShowQ and doing the same steps, it would
>  not start playing until I pressed a few other things, not sure what,
>  but I think I pressed menu Cue -> Load, then it worked.
> Also the midi ports don't show up in the list until
>  an actual left-hand list item is clicked and enabled.
> 
> But still no exit.

cheers, P


More information about the Linux-audio-user mailing list