[LAU] ir.lv2 controls

[Hermann Meyer]

Am 04.07.2018 um 21:41 schrieb Chris Caudle:
> Has anyone figured out the effect of "Stereo in/IR" control on the ir.lv2
> plugin?  From the naming I would have expected similar to the "Dry" and
> "Wet" level controls, but the two sliders (labeled from 0% to 150%) do not
> have the same effect.   I can set the Stereo In and IR slider both to 0%
> and still hear the IR effect on the bus, when I set either to 150% I do
> not hear an obvious change.
>
> I am not using the envelope controls currently, do they perhaps interact
> with those controls in some way?  I noticed that when I hit the "Reset"
> button the envelope and length controls both went back to 100%, the stereo
> in and  IR controls both went back to 100%, but even with the envelope
> active I could not tell what effect the stereo in and IR controls had.
>
> Any hints?
>

According to the description on the githup page that been stereo width 
controls, for the input signal (stereo) and for the convolution kernel 
(ir).