<div dir="auto">+1 for dying capacitors.. that is IMHO the most common problem in equipment.<div dir="auto"><br></div><div dir="auto">If capacitors can not filter out electrical fields, you will have lots of hum and buzz.</div><div dir="auto"><br></div><div dir="auto">/Anders</div></div><br><div class="gmail_quote"><div dir="ltr" class="gmail_attr">On Thu, Dec 19, 2019, 19:04 Len Ovens <<a href="mailto:len@ovenwerks.net">len@ovenwerks.net</a>> wrote:<br></div><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex">On Thu, 19 Dec 2019, Dave Phillips wrote:<br>
<br>
> My audio device has been an M-Audio Delta 66 + Omni I/O breakout box <br>
> that has served me well for many years. Alas, something is now causing a <br>
> severe problem with it. When I turn the unit on in the morning the clip <br>
> and input lights are solid red and green and remain so for up to five or <br>
> more minutes before they go off. Adding to that, my portable room heater <br>
> is now causing a terrible hum through my speakers. I tried another <br>
> heater, got the same results.<br>
><br>
> So, is the problem likely the Delta card ? I have a replacement for it <br>
> that I could swap out, but I thought I'd check with the experts first. <br>
> Or should I get an electrician to check out the wiring in my room ?<br>
<br>
"clip and input lights are solid red and green" These lights are on the <br>
omni I am guessing and so likely the problem is with that box rather than <br>
the D66 card itself. Using mudita24 (not envy24control) on the Analog <br>
Volume tab do you see high level in? (the level for the input is in text <br>
just under the port name (ADC1-3) and can be reset with the "Rest Peaks" <br>
button in the lower left corner) If there is no level or -inf it shows <br>
"(off)". If you are seeing the same high level right after turn on, try <br>
disconnecting the omni i/o and see if the levels are now (after reset) <br>
"off". This test should show that the problem is in the i/o box.<br>
<br>
The most likely thig to be wrong is a capacitor. With the i/o box open <br>
find a larger cap probably close to where the power comes in and after <br>
warm up try spraying this with some kind of "freeze spray" to see if the <br>
problem comes back. replace tha cap that when chilled causes the probalem <br>
to come back. Probably replace the power supply cap just because... <br>
(higher value is ok)<br>
<br>
<br>
--<br>
Len Ovens<br>
<a href="http://www.ovenwerks.net" rel="noreferrer noreferrer" target="_blank">www.ovenwerks.net</a><br>
_______________________________________________<br>
Linux-audio-user mailing list<br>
<a href="mailto:Linux-audio-user@lists.linuxaudio.org" target="_blank" rel="noreferrer">Linux-audio-user@lists.linuxaudio.org</a><br>
<a href="https://lists.linuxaudio.org/listinfo/linux-audio-user" rel="noreferrer noreferrer" target="_blank">https://lists.linuxaudio.org/listinfo/linux-audio-user</a><br>
</blockquote></div>