Could CPU throttling be the problem? I have to disable it when I use synths in JACK or else I get noise, dropouts and IIRC the occasional pop.
On Mon, Nov 28, 2022, 4:20 AM Fabio G < fabio.forall@gmail.com> wrote:
Thanks a lot for your reply, Patrick!_______________________________________________
I will keep experimenting with different combinations of format settings.
About this:
Do you have a "layer" between the drivers (alsa oss etc...)
I am not sure of what you mean (I am not an expert :) ).
Of course the computer has alsa, but as far as I understand all the software involved (virtual keiboard, QSynth, JACK) are connected directly, without intermediaries.
Can you give me some tests to do, to determine whether there is a layer in between or not?
Again, thanks a lot!
Fabio
On 2022-11-28 13:16, Patrick Pouget wrote:
White noise is, in general, due to format mismatch. I mean data types, sample rate, number of channels etc...
I can see 2 causes* Jack should be queried for the format by the application. If you have the problem with many, it is not the case* jack relay on drivers that return wrong informations or no information or a default information. Do you have a "layer" between the drivers (alsa oss etc...) and jack?
On Mon, 2022-11-28 at 09:14 +0100, Patrick Pouget wrote:White noise is, in general, due to format mismatch. I mean data types, sample rate, number of channels etc...
I can see 2 causes* Jack should be queried for the format by the application. If you have the problem with many, it is not the case* jack relay on drivers that return wrong informations or no information or a default information. Do you have a "layer" between the drivers (alsa oss etc...) and jack?
On Mon, 2022-11-28 at 09:03 +0500, Fabio G wrote:
I am experimenting with audio production under Linux Mint 20.3 (based on Ubuntu 20.04). I managed to install a low latency kernel, then I have installed JACK, and Qsynth, following the steps described in this tutorial:
http://www.tedfelix.com/linux/linux-midi.html
Everything seems to work fine if I use Qsynth and pulseaudio: I use the vmpk simple virtual keyboard, and I have good output sound.I have also tested JACK, as suggested in the tutorial using
$ jack-play test.wav
and I hear the right clean output.
However, when I tell Qsynth to use JACK, I have a lot of noise. When I hit a key I have "white noise" for few milliseconds instead of the key sound, and only when it fades I have a little bit of the note that I was supposed to play.
I have the same "white noise" problem is I use Rose Garden.
I have tried to change the sample rate and the frames/period settings, and also the Timeout, in JACK, but the problem stays the same.
Thank you in advance for any help you can give.
Best,
Fabio
_______________________________________________
JackAudio mailing list
JackAudio mailing list
JackAudio@lists.linuxaudio.org
https://lists.linuxaudio.org/listinfo/jackaudio