[LAU] BCF2000

[Kevin Cosgrove]

On 29 October 2007 at 15:18, Jozef Henzl <popcorp86 at gmail.com> wrote:

> Dne pondělí 29 říjen 2007 15:03 Kevin Cosgrove napsal(a):
> > A bit over a month ago my BCF2000 was working just fine.  I
> > didn't have to do much special with it, just plug it in via USB,
> > turn it on, and put it into "Logic Control" mode.  Then it would
> > show up in /proc/asound as card3.  But, now it doesn't show up in
> > /proc/asound.  No messages appear in /var/log/messages.  Where
> > should I start to troubleshoot this?

> Check the usb cable. Or you can reset it to the initial state,
> which AFAIK has usb connection turned on by default.
> /var/log/messages or dmesg should show something like
> usb 4-1: new low speed USB device using uhci_hcd and address 2
> at least

The cable was the problem.  It looked plugged in to me.  But, it
didn't "look" plugged in as far as my computer was concerned.
All is well now.

Thank you!

--
Kevin