[LAU] Zoom R16

[Bob van der Poel]

On Thu, Mar 15, 2012 at 3:06 PM, Jan Depner <eviltwin69 at cableone.net> wrote:

> Little known fun fact - if the on/off switch is in the on position, even
> though you don't have the power cable in or batteries in it, nothing
> will happen when you attach it to the USB port.  Brilliant design!  If
> it's switched off it should come up saying ">AUDIO INTERFACE".  Press
> the right arrow to switch it to ">CARD READER" then press ENTER followed
> by ENTER, and it should show up on your system.  There will be PROJnnn
> directories where the AUDIO data will be stored.

Okay, tried it again. And, it works :)

Silly me ... It didn't occur to me that the computer needed to be
connected at the time of selection. I just thought one set the port to
<card reader> and then you could plug/unplug ... like a camera :)

Nope.

For others as dumb as me:

1. Plug the square end of the USB cable into the R16
2. Plug the flat end into the computer.
3. If the R16 was ON then hit the USB button and select <card>
    or
    If the R16 was OFF then the menu should come up.

Either way, when you unplug the cable you lose the connection and need
to go back to <1>.

Honestly, I think it is easier to just pull the card and use that
directly in the computer :)


-- 
**** Listen to my CD at http://www.mellowood.ca/music/cedars ****
Bob van der Poel ** Wynndel, British Columbia, CANADA **
EMAIL: bob at mellowood.ca
WWW:   http://www.mellowood.ca