[linux-audio-user] Re: UPDATE insmod errors - rme hammerfall multiface UPDATE

[Thomas Charbonnel]

rob canning wrote :
> Hi Thomas,
> 
> hdsploader cand find my card for some reason:
> 
> hdsploader:
> [root at localhost robcanning]# hdsploader
> hdsploader - firmware loader for RME Hammerfall DSP cards
> Looking for HDSP + Multiface or Digiface cards :
> Card 0 : Intel ICH5 at 0xfebfb800, irq 5
> 
> yet lspci -vv reveals:
> 
> 03:0c.0 Multimedia audio controller: Xilinx Corporation RME Hammerfall DSP (rev
> 32)
>         Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping+ SERR+ FastB2B-
>         Status: Cap- 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
>         Latency: 64
>         Interrupt: pin A routed to IRQ 5
>         Region 0: Memory at feae0000 (32-bit, non-prefetchable) [size=64K]
> 
> 
> thanks,
> 
> rob

Hi Rob,

You should first check if the module was properly loaded (/sbin/lsmod), 
then check you modules.conf file. In one of your previous mails one hdsp 
line looked dodgy :

alias snd-card-0ntitlntitled 1ntitled 1ed 1 snd-hdsp

Maybe you should run alsaconf again to start from a clean basis.

Hope this helps,
Thomas