[linux-audio-user] Ardour jack disconnect

[Peter Plessas]

Dear List,

testing ardour and jack to do a concert recording tonight, and get jack 
disconnects:


CONSOLE OUTPUT:

Loading session /fw3_fat/foobar using snapshot foobar
...
Source[Audio 1-4%R.wav]: cannot read peak data from peakfile (256 peaks 
instead of 288) (Success) at start_byte = 114432 _length = 3735552 
expected maxpeaks = 288 npeaks was 288
Source[Audio 1-4%R.wav]: cannot read peak data from peakfile (256 peaks 
instead of 288) (Resource temporarily unavailable) at start_byte = 
157440 _length = 5111808 expected maxpeaks = 288 npeaks was 288
Source[Audio 1-4%R.wav]: cannot read peak data from peakfile (896 peaks 
instead of 368) (Resource temporarily unavailable) at start_byte = 
253056 _length = 8192000 expected maxpeaks = 368 npeaks was 368
zombified - calling shutdown handler
could not attach as client (duplicate client name?)
could not attach as client (duplicate client name?)


MESSAGES:

[ERROR]: failed to connect to JACK
[ERROR]: failed to connect to JACK


THIS HAPPENED:

at stopping an 4 Stereo Channel Recording after 27mins, on a debian 
testing powerpc G3, using a hdsp and qjackctl with the following 
settings (taken from .jackdrc):
/usr/bin/jackd -v -R -p64 -dalsa -r44100 -p512 -n2 -D -Chw:1 -Phw:1 -i18 
-o18
I must say that i record onto an external firewire drive though, so this 
might be an issue here...


The recordings seem ok, but i can only do a reconnect after restarting 
jack. Any suggestions are very welcome!


regards, Peter