[linux-audio-user] Jamin/Ardour export bug and question

[R Parker]

Hi Peder,

--- Peder Hedlund <peder at musikhuset.org> wrote:

> 
> Bug (?) :
> I have a 24 bit stereo track in Ardour connected to
> Jamin and returned
> to another stero track. When the mastering is done I
> export the mastered
> track to 16 bit wav. Everything works, but after
> Ardour has exported 100%
> (and before closing the export screen) it's dead for
> 15-45 secs.
> During this, 'top' shows 85-95% CPU usage for Jamin.
> If I close Jamin before exporting, Ardour responds
> directly.

I see this too. Until someone fixes it, just let it
run it's course.

> Question:
> I have an Ardour session with 17 tracks that have
> EQ, compression and
> the occasional effect pre-fader, a phaser on a
> pre-fader send bus and a
> stereo reverb pre-fader on the master bus.
> If I route the master bus to Jamin and back in on a
> stereo track
> the Jamin output sounds fine, but the stereo track
> ends up with none of
> the effects.
> Is it impossible to do a multitrack mastering with
> the effects intact
> or am I doing something wrong?

Ardour; Options, Miscelaneous, Run Plugins While
Recording. 

There was a point when I thought this was a bug. I
installed Timemachine and started recording mixes into
it. dah!

ron

> HW/SW specs: AMD AthlonXP 1200+, 512MB RAM, SB
> Live!, kernel 2.6.12
> rlimits, jack in RT mode. Ardour CVS from Aug 31 and
> Jamin CVS from
> mid/end July.
> 
> 
>  Regards,
> 
>    Peder
> 



	
		
______________________________________________________ 
Yahoo! for Good 
Watch the Hurricane Katrina Shelter From The Storm concert 
http://advision.webevents.yahoo.com/shelter