[LAU] Solved (I hope) Fedora Core 9, Planet CCRMA, and PulseAudio

[Fernando Lopez-Lezcano]

On Wed, 2008-12-17 at 08:04 -0600, The Other wrote:
> Fernando Lopez-Lezcano wrote:
> > On Sun, 2008-12-14 at 15:20 -0600, The Other wrote:
> >> The Other wrote:
> >>> Then I looked into the /etc/pulse/default.pa file, and went into the 
> >>> ### Load Audio Drivers section and put in this:
> >>>
> >>> load-module module-alsa-sink
> >>> load-module module-alsa-source device=hw:1,0
> > 
> > One more caveat... the load of kernel modules is done now in parallel
> > (if I understand things correctly so that the boot process is faster).
> > 
> > That can have the unfortunate side effect that the order of the
> > soundcards is not necessarily always the same... check the Planet CCRMA
> > pages, there are instructions there on how to solve that. 
>  
> I found your post of September 17, 2008 entitled [Fedora-music-list] 
> sound card order in fc9.  These are the instructions you are referring to?

http://ccrma.stanford.edu/planetccrma/software/installplanetnine.html#SECTION00020500000000000000

-- Fernando


> I'll check them out tonight.
> 
> This may explain why my device=hw:[Audigy2] lines didn't work after a 
> reboot.  I changed it to device=hw:1,0 and that seemed to work.
> 
> cat /proc/asound/cards currently shows:
> 0 [Audigy2]
> 1 [I82801BAICH2]
> 
> But this may be a lucky selection of cards when I rebooted, as you're 
> stating.  Oh well, I thought I had this fixed.
> 
> As I said, later tonight I'll go through your references.
> 
> Thanks Fernando,
> Stephen.