[LAU] Enable/disable toggle in jack-rack with Behringer FCB1010

[Bill Allen]

On Sun, May 3, 2009 at 5:49 PM, Dominic Sacré <dominic.sacre at gmx.de> wrote:

> On Sunday 03 May 2009 23:05:07 Bill Allen wrote:
> > I have set two footswitches to send CC-26 1
> > and CC-26 0 respectively. Then in jack-rack I bind the Enable button to
> > MIDI Controller 26 Min Value 0, Max Value 1. The good news is that when I
> > hit the CC 26 0 switch, if the enable switch for the filter is active, it
> > goes off. Half the battle won. But, I can't get the filter enable to go
> > on with anything I've tried. Using PD I've verified that the pedal is
> > sending the CC 26 1, but still no joy.
> >
> > Any clues or helpful hints?
>
> The on/off controls in jack-rack can be enabled by sending a controller
> value of 127. All values other than 0 and 127 do nothing.
>
> By the way, you may be interested in the UnO firmware for the FCB1010:
> http://www.ossandust.be/
> One of the many improvements over the official Behringer firmware is a
> stompbox mode, which would allow you to use a single button on the FCB1010
> to toggle the effect, with the button's LED showing whether the effect is
> on
> or off.
>

Thanks, that worked. And thanks for the tip. That sounds like exactly what I
need.


>
>
> Dominic
> _______________________________________________
> Linux-audio-user mailing list
> Linux-audio-user at lists.linuxaudio.org
> http://lists.linuxaudio.org/mailman/listinfo/linux-audio-user
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.linuxaudio.org/pipermail/linux-audio-user/attachments/20090503/559808da/attachment.htm