Re: [Jack-Devel] Jack Problems

Thank you holger. The remaining problem I now have is for jack to see the 1818vsl inputs. It looks to me if mixbus will work if jack can just successfully route the 1818vsl inputs to mixbus. The inputs is seemingly reported as some system device inputs in the patchage diagram. Would you mind to take a look. We know now that the outputs to the 1818vsl works as it should, but inputs seems missing. I start jack now by command line and skip the qjackctl abomination. I installed patchage and my setup is as follows. Mixbus runs and is connected properly, and should output sound as its output is connected to the same output as setbfree which works as clear from patchage. The problem with mixbus is the inputs. I have a known to be working and tested spdif keyboard connection that mixbus dont see any input for. It is correctly configured in mixbus, it is just that it now cannot get any signal from jack. See the patchage output. Unfortunately patchage doesnt have a horizontal configuration so text might be blurry as it is all portrait and thus small. "http://grossmann-venter.com/issues/jack/patchage_status-01.png" On 2019-03-26 03:29, Holger Marzen wrote: Ok, I see and get the hang of it rather quickly now. Just a VERY SERIOUS request. Insist that any newcomer completely PURGE pulseaudio before they get help here. It will save everyone a lot of time. Even the taskbar applet which interfered and I had to uninstall it to get jack to work. Once jack works then tell them try to get pulse back in a responsible way. This should be stressed in bold letters on top of the manual and the first response to someone asking for help rather to say that pulse can work but is troublesome. Pulse wasted months of my time and we can avoid it by just removing it as it is written in a ramrod way with no regard to other applications, almost as bad as systemd.