1 Aug
2010
1 Aug
'10
1:39 p.m.
On 07/31/2010 11:14 PM, "Bearcat M. Şandor" wrote:
Thank you. I think i understand all that, but let me
take this apart to
make sure. What you're saying is that having full range speakers only
effects the playback quality of the music not the ambisonics and
that ambisonics itself does not *need* full range speakers, but that
having full range speakers is better than not. Is that correct?
ah, no, sorry. as fons remarked earlier, that mail was kind of sloppy.
it's just that when you embark on the ambisonic trip, there are many
high-end stereo truisms you should be prepared to let go of.
worse yet, ambisonic systems have some clear disadvantages that would
not be accepted in high-end stereo circles - different localisation
ambiguities, sometimes coloration, sometimes extreme phasing, etc.
and there is no reason to accept them in stereo.
at the same time, there is no reason to reject a system that displays
them, because it's the price of good surround sound. you don't reject
stereo for its lack of rear localisation, either...
I think part of my confusion is that i'm still
thinking of it as having
6 or 8 or more *channels* when that is not the case. The speakers are
not steered, they are driven. So you are not going to have a situation
where the speakers behind you are only reproducing high to midrange
information as was the case with Dolby pro-logic or something. Right?
no, never.
I am planning on subs that have their own low-pass
filters. I have a
pair of Anthony Gallo Reference 3.1s but for this ambisonics set up, i'd
get 4 pairs of the Anthony Gallo Stradas and 4 T3 subs. stradas:
http://www.roundsound.com/reference-strada.htm t3:
http://www.roundsound.com/tr-3-subwoofers.htm Most of the stuff on
those pages is marketing of course, but the satellites have a range of
45 Hz - 20 Khz +- 3 db and the subs go down to 22 Hz (no variance given).
That push-pull idea sounds fantastic. I would love it if you'd show me
how to create a set up for a system like that using ambdec, if you have
the inclination and the time. That's what i was planning on using anyhow.
basically, you take fons' example for the octagon, set the speakers up
at the correct angles and then enter the actual distances into the
matrix, so that delay and near-field compensation is correct for your
setup. then you take the example square for the subs, set them into the
corners of the room and again enter the correct distances.
at this point you have two ambdec instances running, one for the tops,
one for the subs. you'd need to adjust the relative loudness with
ambdec's faders. once you've determined the correct relative levels, you
can factor them into the matrix coefficients of the sub decoder and run
both ambdecs at 0dB. now you can hack both matrices into one and end up
with a 12 channel ambdec configuration: 8 tops and four subs. easier to
start up in daily use.