26 Dec
2009
26 Dec
'09
12:25 a.m.
Am Samstag, den 26.12.2009, 02:48 +0100 schrieb Ralf Mardorf:
This is something I have planned for a while but never got round to
finishing.
The main problem was at the time I wrote jackEQ I didn't fully
understand how to use a config file. 6 years later I should have another
go at it...
Anyway have you checked out either of these tools?
http://home.gna.org/jackmixer/
Thank you.
Nedko referred to this one off-list and I'll compile it later.
Unclear GUI. I don't like it.
_______________________________________________
Linux-audio-dev mailing list
Linux-audio-dev(a)lists.linuxaudio.org
http://lists.linuxaudio.org/listinfo/linux-audio-dev
Patrick Shirkey wrote:
> On 12/26/2009 01:46 AM, Ralf Mardorf wrote:
>
>> I still have got one major problem. I don't know any virtual mixing
>> console for Linux that is able to restore fader positions. I'm not
>> talking about mixers for applications like Qtractor, just for a mixer to
>> connect Calf Monosynths and Jconv. I only need something similar to jackEQ.
>>
>>
That's the special task, were jcgui is build for. All settings
will auto
store, you could save them additional as preset(session).
Only a small rework is needed to make a multi channel mixer out of the
source. :-)
hermann