28 Aug
2008
28 Aug
'08
12:34 a.m.
Jens M Andreasen wrote:
The OCZ NIA (without any drivers) reports itself
in /proc/bus/input/devices as a standard HID (Human Interface Device),
after which it starts sending a steady stream of sensor-data, formatted
as a binary struct input_event (see linux/input.h)
So would it be best to convert this to osc for passing around control
signals or midi or leaving it raw?
Now then what sensor is supposed to be connected to
what is another
matter, but I suppose that if you try one out you will be able to figure
out what is going on ...
On Wed, 2008-08-27 at 11:35 -0500, Nathanael Anderson wrote:
--
Patrick Shirkey
Boost Hardware Ltd.
I've been thinking about the same thing.
Specifically I wanted to try
and use an OCZ NIA for drum input into hydrogen. I've seen a few
videos of them people demoing the unit, but don't personally know
anyone that's tried one. There is no linux support afik either for
them. I'd be interested if you make any progress to hear about it.
Nathanael
_______________________________________________
Linux-audio-dev mailing list
Linux-audio-dev(a)lists.linuxaudio.org
http://lists.linuxaudio.org/mailman/listinfo/linux-audio-dev
_______________________________________________
Linux-audio-dev mailing list
Linux-audio-dev(a)lists.linuxaudio.org
http://lists.linuxaudio.org/mailman/listinfo/linux-audio-dev