11 Jan
2012
11 Jan
'12
1:51 p.m.
On Wed, Jan 11, 2012 at 3:59 AM, Fons Adriaensen <fons(a)linuxaudio.org>wrote;wrote:
But in most cases such effects would be performed on
the mono channels
before they are mixed into B-format.
Thanks for that.
You need a reverb that produces B format, 100% wet. It is driven by
post-fader auxiliary sends on the mono channels before
they are panned
and mixed, and the output is added to the B-format master bus.
Ideally you also need to control the relative delay of the reverb send
and the input to the panner (direct sound) - it depends on distance.
Yes, this is all easily possible, no problems.
You can use zita-dpl1 for B-format peak limiting, and
zita-rev1 for
reverb, or use one of the AMB reverbs available for jconvolver.
I've also an AMB capable compressor but this is not yet released.
While reading around I came across zita-rev1, but it seem has stereo
inputs, duplicate the mono signal to both inputs, or would you advise to
drive it with a stereo signal? I could pan the mono->stereo based on the
ambi panner control, and then send the stereo to zita-rev1, and mix in the
returned B-format?
Just loaded up zita-dpl1 -k 4, using it as an insert is no problem :)
Cheers, -Harry