29 Dec
2009
29 Dec
'09
1:25 p.m.
Sorry, Ralf, I can't hear a different, when I set all controllers in
Jc_Gui to zero, and move the wet/dry slider to the right side, connect
ONLY Jc_Gui:in_0 /in_1 and out_0 /out_1, or disconnect jconvolver from
Jc_Gui and run it plain.
In the Jc_Gui engine, in this case, only additions and multiplications
with 0 was add/sub, the only diff is the use from denormal protection,
witch is needed for the tone unit. + 1e-20 , I can't believe that one
could hear that.
Only when you connect all 4 Jc_Gui ports for in and output, the source
will double up and overdrive.
regards hermann
Am Dienstag, den 29.12.2009, 08:51 +0100 schrieb Ralf Mardorf:
hermann wrote:
Mostly you need to recalibrate the gain setting
in jconv settings widget
Correct, this was the reason for not really getting reverb, but now
there's another problem. The sound is muddy.
I'm not able to get the sound as bright and clean as it is for the
attached configuration. I don't think it's because of the mono input, it
sounds like there would be bad EQ settings, but the EQ's for Jc_Gui are
set to 0. The signal tends to overdrive, it's not easy to keep the
balance between the jconvolver widget and the additional Jc_Gui mixer.
Anyway, LAD might be the wrong forum for this, I should join a user list
for solving this issue.