14 Jul
2004
14 Jul
'04
7:46 a.m.
On Wed, 2004-07-14 at 04:51, Takashi Iwai wrote:
At Tue, 13 Jul 2004 17:45:30 -0400,
Lee Revell wrote:
I am runnign at 48kHz so it's actually 0.666 ms. But, the average
response is quite good, 20-30 microseconds. The spikes are infrequent
enought that I think this is achievable. If not then 64 frames
definitely is.
So what is the difference between the above message and an XRUN? I
thought an XRUN occurred when the handling of the IRQ is delayed more
than the buffer size.
Lee
On Tue, 2004-07-13 at 17:29, Andrew Morton wrote:
I think yes. 32 frames / 44.1kHz = 0.725 ms.
Lee Revell <rlrevell(a)joe-job.com> wrote:
Not sure. Here is what Takashi had to say about it:
"The message appears when an unexpected DMA pointer is read in the
interrupt handler. Either the handling of irq was delayed more than
the buffer size, an irq is issued at the wrong timing, or the DMA
pointer reigster is somehow screwed up.
Since you're using quite small buffer, I guess the former case."
My response:
"I thought this was what an XRUN was, when the handling of the irq is
delayed more than the buffer size. Sometimes these messages are
associated with XRUNs, sometimes not."
Haven't heard back yet.
Is it possible that I am simply pushing my hardware past its limits?
Keep in mind this is a 600Mhz C3 processor.
Would this explain these? When running JACK with settings that need
sub-millisecond latencies, I get them when I generate any load at all on
the system (typing, switching windows, etc). I also get lots of these
if I run JACK from an X terminal, but very few if I run it from a text
console, even if X is running in the background.
Jul 13 14:36:16 mindpipe kernel: ALSA
/usr/src/alsa-cvs-1.0.5/alsa-driver/alsa-kernel/core/pcm_lib.c:199: Unexpected hw_pointer
value [1] (stream = 0, delta: -25, max jitter = 32): wrong interrupt acknowledge?
I'm wondering what this message actually means. "Unexpected hw_pointer
value"?
Does this actually indicate an underrun, or is the debug code screwy?