On Sat, Jul 17, 2010 at 10:56:47PM -0400, Gene
Heskett wrote:
Some lubricant obviously made its way in there,
and one would have
to assume that the switched current was sufficient to cause a
microscopic arcing, which will in time create a smoke film on the
internals, which is what you were measuring, and which caused the
PSU to think the button was pressed full time. Lubricants are a
good idea only on a circuit that can be called a dry circuit, where
dry=microamp currents at very low voltages.
Ah, yes, these plastic things are often lubricated.
Washing it out with acetone was ok, but I would
probably have
reached for a can of paint thinning alcohol as it is less likely to
degrade the plastics.
I know, but the acetone was all I had available...
Ciao,
Fruit acids or pure alcohols are effective and relatively harmless, but
most effective are products by chemical companies, there are cleaners
with qualities comparable to penetrating oil, but made to fit to
electrical properties. Those cleaners will clean, resp. repair and
protect.