28 Feb
2006
28 Feb
'06
9:07 a.m.
On Tue, 2006-02-28 at 16:04 +1100, Jason White wrote:
On Mon, Feb 27, 2006 at 09:17:54AM -0500, Paul Davis
wrote:
punch status is 100% irrelevant here - it should be off. if turned on
for a given channel, it means that the channel's input will stream be
copied to its output stream. pass-thru should also not be used, since it
basically turns on this behaviour for every channel.
aplay -D plughw:1,0 file.wav
this will actually put the output across all outputs, but it should
accomplish most of what you want.
Aplay ran without any error messages but there was no output produced. I set
all of the channels to "on", and also tried enabling the "pass-thru"
option
but none of this had any audible effect. Whenever I ran aplay again, the
channels ("punch status" in the /proc/asound/card1/rme9652 file) were somehow
reset to "off". An example of /proc/asound/card1/rme9652 appears
below.
ADAT Sample rate: 44100Hz
ADAT1: No Lock
ADAT2: No Lock
ADAT3: No Lock
this suggests that you do not have correct connections established. at
least one of these should say "Lock" or "Sync". what is the interface
connected to, and how is clocking being handled?