Re: [linux-audio-user] RME Digi9652 with Alsa

On Tue, Feb 28, 2006 at 08:10:32AM -0500, Paul Davis wrote: It's connected to the optical input of an RME ADI-2 a/d d/a converter, the clock setting of which is configured for slave mode, i.e., to synchronize with the input signal. The only output that works currently is /dev/audio1 (OSS emulation), which sends output to all channels simultaneously. I have attempted using the -erc operator of Ecasound to copy the output to different channels individually, but short of trying all 27 channels I haven't been able to get any output through to the converter. When playing through /dev/audio1 the /proc/asound/card1/rme9652 parameters are as follows. I am getting clicks in the output, for whatever reason. RME Digi9652 (Rev 1.5) (Card #2) Buffers: capture cec00000 playback cee00000 IRQ: 11 Registers bus: 0xec000000 VM: 0xd0820000 Control register: 45039 Latency: 1024 samples (2 periods of 4096 bytes) Hardware pointer (frames): 0 Passthru: no Clock mode: master ADAT1 Input source: ADAT1 optical IEC958 input: Coaxial IEC958 output: Coaxial & ADAT1 IEC958 quality: Consumer IEC958 emphasis: off IEC958 Dolby: off IEC958 sample rate: error flag set ADAT Sample rate: 44100Hz ADAT1: No Lock ADAT2: No Lock ADAT3: No Lock Timecode signal: no Punch Status: 1: off 2: off 3: off 4: off 5: off 6: off 7: off 8: off 9: off 10: off 11: off 12: off 13: off 14: off 15: off 16: off 17: off 18: off 19: off 20: off 21: off 22: off 23: off 24: off 25: off 26: off