31 Aug
2006
31 Aug
'06
3:31 a.m.
On Wed, 30 Aug 2006, Spencer Russell wrote:
Do you have JACK set to playback only?
I did, yes, since I'm presently mixing already recorded tracks.
If I recall, I had this problem with saved sessions. A
new session
would work, I think, but once I saved it and opened it again, I
couldn't add a bus if JACK was set to playback only. If you set JACK
to full duplex the problem should go away.
Indeed it did! Thank you _very_ much!
I guess not a lot of people run Ardour with JACK on
playback only.
Could be. Perhaps I don't need to change Jack's configuration based on
whether I'm tracking or mixing? (I do have a few saved configurations,
for example, because some projects I'm working on were recorded by
others with a different sample rate than I normally like to work with,
and it's a lot easier, and sounds better at least on my system, to just
adjust Jack than it is to resample the tracks.)
Alright, then ... on with the mix! :-)
--
----------------------------------------------------------------------
Sylvain Robitaille syl(a)alcor.concordia.ca
Major in Electroacoustic Studies Concordia University
Faculty of Fine Arts / Music Department Montreal, Quebec, Canada
----------------------------------------------------------------------