17 Nov
2010
17 Nov
'10
7:35 p.m.
I have a fa-101. To change the samplerate you have to turn the knob choosing
samplerate, then turn off the card on the back side wait a little while and
turn it on again. Then change the samplerate in settings in jack and then
start jack.
Hope it helps..
I record in 88.2Khz on Ubuntu 10.04 via Jack, works very well
Kind Regards
Thomas Hedegaard
2010/11/16 Lorenzo Sutton <lsutton(a)libero.it>
Hi try:
- stopping jack
- unplug the card
- change the sample rate knob
- replug the card
- change the sample rate in jack settings (or in jackd command line)
- start jack
Does it work?
Lorenzo
Dragan Noveski wrote:
hallo list,
i borrowed yesterday an edirol fa-101 in order to try if it will work on
my sidux/aptosid mix.
after some tweaking around and reading errors in qjack's messages window i
get it to work really nicely in 48kHz mode. with all other sample rates
which the card seems to be providing ( and is providing on my friends
mac...) i could not get it to run.
on a ffado page the card is listed as 'full supported', so i understood
that also different SR should work. i also realized that turning the SR knob
on the card does not changes nothing and that the SR is given in jackd's
command line.
could someone who is using this card please make some comments on this?
cheers,
doc
_______________________________________________
Linux-audio-user mailing list
Linux-audio-user(a)lists.linuxaudio.org
http://lists.linuxaudio.org/listinfo/linux-audio-user
_______________________________________________
Linux-audio-user mailing list
Linux-audio-user(a)lists.linuxaudio.org
http://lists.linuxaudio.org/listinfo/linux-audio-user