3 Aug
2008
3 Aug
'08
4:50 p.m.
On Sunday 03 August 2008 14:34:57 jdd wrote:
Nah, give it go. Try ardour and traverso...
Justin Smith a écrit :
qjackctl or "Jack Control" makes things easy, it is probably not needed.
In qjackctl, you can start and stop jack. When stopped, you can click setup
and adjust your settings as well as configure multiple cards and the settings
you want for each and also settings for different uses if you like.
I have a preset name on this machine called int48 which handles my onboard
sound and it only does 48000. I have another prest name called usb441 and I
use that for the zoome h4 at 44100. Hope this info helps you to make
progress.
On Sun, Aug 3, 2008 at 5:35 PM, drew Roberts
<zotz(a)100jamz.com> wrote:
well, thanks for you two. I installed jack (and all the stuff that
goes with) and then could record with the H2 mike.
However, after disconnecting the H2, I can't recover the usual sound.
Is there a jack switch to use sound card 0 or sound card 1?
> If you know about jack, try jack and
qjackctl.
I didn't see qjackctl, is that what I need? I have a zoom H2, it is 100% compatible with
Linux.
I see that now :-)
I can use it as a USB sound card, but only with
two of its microphones
at a time, and a maximum sampling rate of 48k (I think these are also
limitations under any other OS, because of USB bus speed).
I nevre use better anyway
I have found it more useful to record using the
H2 alone, then grab
the files off of it as if it were a flash drive.
yes, I do that now, but I want to do multi track recording (may be I'm
not ready yet :-)
thanks
jdd
all the best,
drew