31 Jan
2011
31 Jan
'11
4:53 a.m.
On Fri, Jan 28, 2011 at 04:44:47PM +0100, fons(a)kokkinizita.net wrote:
On Fri, Jan 28, 2011 at 03:37:21PM +0100, Renato
wrote:
Really? So that little bit of mung before the "snap" in an IR is distortion, not
"predelay" or "early reflections" or any such thing? Wow, that's
good to know. I have to get busy and clean up some IR's then.
fons(a)kokkinizita.net wrote:
They have to be of reasonable quality and FR, but any remaining
small errors can easily be calibrated out. You just take the
direct sound (for a good speaker + mic this will be the first few
ms of the IR) as a reference.
A few percent distortion (most speakers will have this) does not
matter if the measurement is done in the correct way: after the
deconvolution the distortion products will appear *before* the
real IR and they can be removed easily. Starter guns, electric sparks, exploding balloons
or preservatives,
etc. are not the best way to do this. You get a much more accurate
result and a much better S/N ratio using a sine sweep and
deconvolution instead. Aliki (available on my website) can do this.
See <http://www.kokkinizita.net/papers/aliki.pdf> for an introduction.
The actual application does not have all the features explained in
the paper but it will do the basic IR measurement.
question: why the amp/speakers don't have to be high quality
flat-response monitors (as I think Julien is saying), but the mic does? Also, do mic vendors offer files with the
frequency response of the mic
so one can "multiply the inverse of it" with the spectrum of the
signal recorded with said mic, taking mic charateristics out of the
equation (at least theoretically)?
The high quality ones will have tight specs and usually come with
a measured FR or other calibration data.
There are a few other points to consider.
Most speakers will be directional at all but the lowest frequencies.
It depends on your application if this matters or not. If it does
(e.g. to measure room acoustics according to international standards)
you need an omnidirectional speaker. These are usually made as a
dodecahedron of small speakers. See <http://www.gizmag.com/go/3894>
for an example.
Also omni mics will have some directionality at high frequencies, and
that is why they come in two forms: calibrated for flat FR on-axis
(plane wave), or for flat FR in a diffuse field (averaged over all
directions). The difference matters only at very high frequencies.
Some measurement come with a small conical diffuser which can be
attached in front to improve diffuse-field response.
Ciao,
--
FA
There are three of them, and Alleline.
_______________________________________________
Linux-audio-user mailing list
Linux-audio-user(a)lists.linuxaudio.org
http://lists.linuxaudio.org/listinfo/linux-audio-user