Re: [LAU] kernel 5.15 irqs

On Thu, 24 Feb 2022, Brent Busby wrote: It depends... 1) on what latency you wish to work with 2) on the mother board and CPU 3) on how the various irq happen to get prioritized 4) on how much use the core your device is using gets 5) numerous other things It is (remotely) possible that someone might have a setup where their audio device just so happens to end up prioritized over almost everything else. Or that the required latency is high and the computational load is low enough that audio is just always ready when the device is. However, in most cases this is not true. Remember that Motherboards, CPUs, GPUs, etc. are a product to be sold. The general measure of a "good" product is data throughput and so all these things are designed to get maximum throughput all other things being equal. Another thing concidered "good" is operational feel. This might make mouse responce seem more important than low latency sound for example. I did read some of the Intel documents about HDA audio. One of the "features" is low latency audio.... which they define as at least 30ms latency. Perhaps not very good for guitar effects. Threadirqs allows the user to change some of these priorities, to make sure your audio device gets taken care of before your mouse or the internal audio. Effectively, you are able to take a machine designed for one use and make it work better at another use. This means less xruns at very low latencies and less xruns even at higher latencies if you are pushing your proccessor hard. It is not magic but a good start to tuning a system for audio work. While there have been many rules of thumb in the past for tuning a system for audio, the reality is that each system is different and requires different steps (with testing). The other reality is that some of the newer systems have fewer choices (like laptops) and the user will just have to get used to higher latency audio use. Of course USB 2.0 audio has it's own group of difficulties as well. Perhaps USB3 or thunderbolt will offer something that helps. -- Len Ovens www.ovenwerks.net