5 Mar
2005
5 Mar
'05
10:39 a.m.
On Sat, Mar 05, 2005 at 12:25:13PM +0100, Karsten Wiese wrote:
Am Samstag 05 M?rz 2005 09:20 schrieb Spencer
Russell:
srussell@slingshot:~$ cat /proc/interrupts
CPU0
0: 23968893 XT-PIC timer 0/68893
1: 5085 XT-PIC i8042 0/5085
2: 0 XT-PIC cascade 0/0
7: 0 XT-PIC parport0 0/0
8: 3 XT-PIC rtc 0/3
10: 0 XT-PIC VIA686A 0/0
11: 9538103 XT-PIC yenta, uhci_hcd 0/38103
12: 36200 XT-PIC i8042 0/36200
14: 101724 XT-PIC ide0 0/1723
15: 13 XT-PIC ide1 1/12
NMI: 0
LOC: 0
ERR: 0
MIS: 0
Hmm, it does look like my PCMCIA driver is also on the same
interrupt. I don't have any PCMCIA cards in now, but could that
still be causing problems?
OK, So as per these several suggestions, I've
now tried the US428
with a vanilla 2.6.11, a 2.6.11 with Ingo's preempt patch and
full preemption, nrpacks=4, apm and acpi not compiled in the
kernel, and without my usb ethernet card plugged in. I'm still
getting the "Sequence Error!" messages, then a couple seconds
later qjackctl dissapears.
Please post the output of
$cat /proc/interrupts
maybe the usb-interrupt is also busy with something else...
Also make shure that any option in your bios sounding
like "usb
legacy support" is disabled.
I have kind of a strange BIOS, where pretty much the only option
I have when I go into the setup is boot order, there isn't
anything about USB support.
Thanks for the help,
Spencer