28 Feb
2006
28 Feb
'06
1:04 a.m.
On Mon, Feb 27, 2006 at 09:17:54AM -0500, Paul Davis wrote:
aplay -D plughw:1,0 file.wav
this will actually put the output across all outputs, but it should
accomplish most of what you want.
Aplay ran without any error messages but there was no output produced. I set
all of the channels to "on", and also tried enabling the "pass-thru"
option
but none of this had any audible effect. Whenever I ran aplay again, the
channels ("punch status" in the /proc/asound/card1/rme9652 file) were somehow
reset to "off".
An example of /proc/asound/card1/rme9652 appears below.
I have searched the WEb for further information. Questions have been asked on
this and other mailing list concerning this card, but I can't find any answers
in the archives.
Any help would be much appreciated. When I get this working I will document my
findings to help others.
RME Digi9652 (Rev 1.5) (Card #2)
Buffers: capture cec00000 playback cee00000
IRQ: 11 Registers bus: 0xec000000 VM: 0xd0820000
Control register: 402d
Latency: 4096 samples (2 periods of 16384 bytes)
Hardware pointer (frames): 0
Passthru: no
Clock mode: autosync
Pref. sync source: ADAT1
ADAT1 Input source: ADAT1 optical
IEC958 input: Coaxial
IEC958 output: Coaxial only
IEC958 quality: Consumer
IEC958 emphasis: off
IEC958 Dolby: off
IEC958 sample rate: error flag set
ADAT Sample rate: 44100Hz
ADAT1: No Lock
ADAT2: No Lock
ADAT3: No Lock
Timecode signal: no
Punch Status:
1: off 2: off 3: off 4: off 5: off 6: off 7: off 8: off
9: off 10: off 11: off 12: off 13: off 14: off 15: off 16: off
17: off 18: off 19: off 20: off 21: off 22: off 23: off 24: off
25: off 26: off