29 Oct
2007
29 Oct
'07
11:29 a.m.
Dne pondělí 29 říjen 2007 15:03 Kevin Cosgrove napsal(a):
Hi,
A bit over a month ago my BCF2000 was working just fine. I
didn't have to do much special with it, just plug it in via USB,
turn it on, and put it into "Logic Control" mode. Then it would
show up in /proc/asound as card3. But, now it doesn't show up in
/proc/asound. No messages appear in /var/log/messages. Where
should I start to troubleshoot this?
Check the usb cable. Or you can reset it to the initial state, which AFAIK has
usb connection turned on by default.
/var/log/messages or dmesg should show something like
usb 4-1: new low speed USB device using uhci_hcd and address 2
at least
--
Jozef Henzl
http://popcorp.org