12 Dec
2010
12 Dec
'10
1:40 p.m.
On Sun, Dec 12, 2010 at 3:36 PM, Nick Copeland
<nickycopeland(a)hotmail.com> wrote:
The AKS is non functional, it is documented somewhere
on the website but I
will consider adding a big capital letter disclaimer for the few that are
unfinished. If you start it with -libtest you can just see the GUI, I use
that during development.
The Rhodes is the DX algorithm with a preset. Will have a look at it here.
Bristol is not going to be the best Rhodes you will find on open source,
It's not even the best Rhodes emulator in bristol! some soundfonts and most
samples will give you better results.
Regards, nick
Nick, np. I'll refrain from reporting anymore until you announce an
update, and we can test finished code.
Apologies for the noise.
Regards,
Alex.
--
www.openoctave.org
midi-subscribe(a)openoctave.org
development-subscribe(a)openoctave.org
From: compose59(a)gmail.com
Date: Sun, 12 Dec 2010 14:17:41 +0300
Subject: Re: [LAU] bristol synths hang
To: nickycopeland(a)hotmail.com
CC: rennabh(a)gmail.com; linux-audio-user(a)lists.linuxaudio.org
On Sun, Dec 12, 2010 at 12:56 PM, alex stone <compose59(a)gmail.com> wrote:
Nick, just updated to 0.60.7 (Gentoo Ebuild),
added your suggested cli
options to a bristolrc, and all is good so far.
Gentoo 64bit, 2.6.33.7-RT.
Regards,
Alex.
--
www.openoctave.org
midi-subscribe(a)openoctave.org
development-subscribe(a)openoctave.org
Nick, been through the synths, and only 2 seem to be a bit problematic, so
far.
aks- opens, but no jack or alsa ports appear, and it zombifies shortly
after that.
rhodes- opens, and is playable, but runs CPU up to 100 percent, and
hangs, which then needs to be killed off in a terminal.
Alex.
--
www.openoctave.org
midi-subscribe(a)openoctave.org
development-subscribe(a)openoctave.org