31 Jan
2011
31 Jan
'11
12:01 p.m.
On Sun, Jan 30, 2011 at 07:53:18PM -0800, Ken Restivo wrote:
No, the little wobbles that can appear before the main impulse (which
is the direct 'dry' sound and should be removed anyway if the IR is
used for reverb) are not the distortion, but the result of
* the limited frequency range of the sweep (it usually doesn't start
at 0 Hz and stops before Fs/2),
* the imperfect FR of the speaker + mic.
The distorion appears much earlier.
Suppose you have log sweep going up in frequency by 1 octave per
second. If the speaker produces 2nd harmonic distortion, the
second harmonic will appear in its output 1 second before the
sweep reaches this frequency. The result after deconvolution is
a small 'impulse' 1 second before the main one. Usually you won't
even see it as the time range of the deconvolution is programmed
to start later.
In a similar way, the 3rd harmonic will appear 1.585 seconds early,
the 4th harmonic 2 seconds, etc.
Ciao,
--
FA
There are three of them, and Alleline.
On Fri, Jan 28, 2011 at 04:44:47PM +0100,
fons(a)kokkinizita.net wrote:
A few percent
distortion (most speakers will have this) does not
matter if the measurement is done in the correct way: after the
deconvolution the distortion products will appear *before* the
real IR and they can be removed easily.
Really? So that little bit of mung before the "snap" in an IR is
distortion, not "predelay" or "early reflections" or any such thing?
Wow, that's good to know. I have to get busy and clean up some IR's
then.