Am Freitag, 6. November 2009 schrieb Arnold Krille:
On Thursday 05 November 2009 23:40:43 Hartmut Noack
wrote:
So again a last try: can anybody recommend any
USB-interface recently
available for about 50 Eur/USD ?
I was going to recommend the edirol um22 like I own one. But then again you
are probably searching for a usb-audio interface ;-)
Lets face it: in the 50€ range there is nothing to expect except for
behringer and maybe terratec. Both cheap and noisy as hell. And not really
better then any built-in sound-card.
Arnold
Arnold,
you're right - the pcm2902 codec is broken by design. The internal voltage
reference shows a terrible distortion because the 1 kHz usb clock isn't
decoupled properly. The data sheet
(
http://focus.ti.com/lit/ds/symlink/pcm2902.pdf) recommends the use of an
external voltage reference for "a high-performance application" (figure 37) -
unfortunately Behringer uses the circuit for "a simple application" (like
figure 39).
I tested my UCA202 with Fons' jaaa and got a "nice" peak at 1 kHz - it went
away after adding a REG103-A to my UCA (you can get free samples from TI).
Ciao Martin