24 Sep
2008
24 Sep
'08
7:34 a.m.
Arnold Krille wrote:
Am Mittwoch, 24. September 2008 schrieb
simone-www.io-lab.org:
note that the number of
ports has nothing to do with the hw:x parameter.
the hw:x parameter designates the controller to use. All ports on one
controller are part of the same bus, and are treated the same.
if you have a built-in controller, you might have to use hw:1.
Greets,
Pieter
thank you for your interest in this desperate
case ;)
yes everything is connected and powered on as supposed to be
the only thing i come to think about is: i am using a PCMCIA card
which has 3 ports but in Jack i don t have nay ohter choise than hw:0
, that may be the symptom of an unrecognized device?
If your fw-card has three ports, there are two possibilities:
a) pass hw:X with X in {0,1,2} in the jackd-commandline