16 Dec
2019
16 Dec
'19
8:28 p.m.
dear Len, thanks for replying!
Am Montag, den 16.12.2019, 08:18 -0800 schrieb Len Ovens:
exactly, that there's a signal (physically) incoming is indicated in
the 2nd device (and also in the 1st, as usual) but not in the daw, i.
e. its meters (but in the 1st). if I record from both devices, only
1st/master device's tracks have the signals/content, but the tracks of
the 2nd/slave device are empty.
On Mon, 16 Dec 2019, soffioalcuore(a)posteo.net wrote:
no, # was just to identify the following as code/terminal output. sorry
for the confusion, now I'm aware I should better use $ for that.
#zita-a2j -d hw:H4 -r 48000 -p 512 -n 2
does the # mean you are running things as root? Jack and zita should
only
ever be run as a regular user and never as root/system. and I can see
the zita-bridge both in the graph window of qjackctl
and
in my daw (reaper).
the problem is that I don't get any signal from the device
connected by
the zita-bridge. I have also tried to change both devices - without
success. furthermore, I've tried to leave some of the parameters
(-p
and -n) out.
By no signal you mean there is a mic on the input but the audio does
not
show up? (The meters on the device itself show level?) Does the signal ever show up on each device A) when
not running jack?
B)
as the sole jack master?
a) yes, they normally do.
b) yes.
Is the device you are using as jack master also the
device you are
using
for monitoring? (output to speakers/heagphones?)
yes, by now, the master device is, as usual, the monitoring device. for
the moment I'm just focussing on the inputs.
--
Len Ovens
www.ovenwerks.net
I hope that helps. thanks again!
christoph