16 Dec
2004
16 Dec
'04
3 a.m.
thanks joq for going through the how to....
And as you had said that Audio 3 will be a mono track is not
true..>because>> Audio 3(out 1/out 2) is a stereo track..... i m recording
guitar on Audio1 (track1) and Audio 2, so they both are mono... and i m
then putting the output of the master track (after these two tracks are
recorded) into jamin>>> ie master is stereo which will go into jamin
(left/right) stereo... then im taking the balanced/mastered out(stereo) of
jamin and connectin it to 'Audio 3' , so , hence Audio 3 becomes
stereo.... and so we are exporting a stereo audio file...
i have understood your point completely .. are you saying that if we have
2 mono channels we put one on the left and the other on the right while we
export ..?
...#ish
On Tue,
2004-12-14 at 11:33, ish(a)sarai.net wrote:
Nice, helpful writeup. I did notice a significant error you might
want to correct, however.
On this page...
http://users.sarai.net/~ish/Exporting_audio.html
Your example checks *both* Left and Right stereo channels when
exporting Audio 3:out-1 and Audio 3:out-2 to a WAV file. I believe
this gives "mono" output in a stereo file (in the sense that both
channels will be the same). I recommend checking Left for Audio
3:out-1 and Right for Audio 3:out-2. That will render the stereo
outputs from JAMin correctly.
--
joq
Hi every one ... i ve witten a kind of a rough
How-to(Draft) for
initial
recording using Ardour... and using JAmin along
with it via
JACK(jackd).
This was primarily go give a basic how to of
intial acoustic
recording.
And how a mastering software, which in this case
is JAmin can be used
to
tweak the recording to produce a well
spaced/MAstered
recording...(Basically to achive the stuff in youe head) . Well this
is
just a start... and any input from your side will
be helpful... so
please
> check out the following site ...
>
> http://users.sarai.net/~ish/contents.html