5 Apr
2005
5 Apr
'05
7:27 p.m.
Hi Thomas!
Thanks for your reply!
I have now tested alsa-drivers-1.0.9rc1 with hotplug support in the
kernel, but without success. When i boot into OSX, load the firmware
there, and do a warm-reboot into debian, the card works, even
reinserting and putting the computer into sleep mode doesn't stop the
card from working.
But after a coldboot into debian, the card remains uninitialized, giving
the same error as described below.
I am fairly stuck here.
Thanks for _any_ help.
Peter
Thomas Charbonnel wrote:
Dear list,
this is a bit complicated, due to big/little endian issues, perhaps. I
am trying to load the firmware into my hdsp pcmcia card.
I am getting the fifo timeout:
peter:~# hdsploader
hdsploader - firmware loader for RME Hammerfall DSP cards
Looking for HDSP + Multiface or Digiface cards :
Card 0 : PowerMac Screamer Rev 0
Card 1 : RME Hammerfall DSP at 0xf3000000, irq 58
Upload firmware for card hw:1
Hwdep ioctl error on card hw:1 : Input/output error.
I am using debian testing, running a 2.6.8 kernel with manually compiled
1.0.8 alsa drivers on a G3 powerpc laptop.
cardbus version is 11 (rev 0b)
the card is loadable out of osx.
i am stuck here, and don't know what to do now.
any suggestions are very welcome!
thanks,
Peter
Hi Peter,
From 1.0.8 on, the new method for uploading the firmare is through hotplug
and the kernel generic firmware loading mechanism (if compiled in). You
shouldn't have to use hdsploader anymore. Anyway you should definitely use
CVS or the 1.0.9 RCs, as there were significant problems with the hdsp
driver in 1.0.8 that have been fixed since then (firmware loading,
endianness issues, metering).
Thomas