22 Feb
2006
22 Feb
'06
6:52 a.m.
Quoting Ismael Valladolid Torres <ivalladt(a)punkass.com>om>:
I run the command below and it works, it plays the
wave file:
$ aplay -D default shared/testing.wav
Playing WAVE 'shared/testing.wav' : Signed 16 bit Little Endian, Rate
11025 Hz, Mono
However the command below fails:
$ aplay -D hw:0,0 shared/testing.wav
Playing WAVE 'shared/testing.wav' : Signed 16 bit Little Endian, Rate
11025 Hz, Mono
aplay: set_params:901: Channels count non available
I thought it was posible to select audio channels this way using
aplay. No .asoundrc here. Any ideas?
your system probably has a global /etc/asound.conf which maps default to a
plughw device of some sort. That way alsa converts the mono 11025hz signal
to something your soundcard is capable of playing.
With hw:x,y you can select the hardware (hw) device (x) and subdevice (y).
It depends on your configuration which number each device has, and it
depends on your hardware what subdevices each device has. Subdevices are
_not_ channels.
Sampo