Re: [linux-audio-user] ecasound help

On Wed, 20 Oct 2004 cv223(a)comcast.net wrote: The easiest way to achieve this is to use the soundcard's own mixer for monitoring the incoming audio signals. With Delta1010LT (and other ice17xx cards), launch envy24control and on the 'Monitor mixer' tab turn on volume for for "Hw in 1", "Hw in 2" and so on, and then on 'Patchbay / router' tab select "Digital Mix" as the source of "Hw out 1", and others. With consumer cards, the same can be achieve by unmuting "Line in" (or "Mic in") and turning up their volume. If you for some reason want to monitor audio specifically by routing the audio through ecasound, the correct syntax would be: ecasound -r -b:256 -a:1,2,3,4,5,6,7,8,mon1 -f:16,8,48000 -i alsa,default \ -f:16,1,48000 \ -a:1 -o mono-1.wav \ -a:2 -o mono-2.wav -erc:2,1 \ -a:3 -o mono-3.wav -erc:3,1 \ -a:4 -o mono-4.wav -erc:4,1 \ -a:5 -o mono-5.wav -erc:5,1 \ -a:6 -o mono-6.wav -erc:6,1 \ -a:7 -o mono-7.wav -erc:7,1 \ -a:8 -o mono-8.wav -erc:8,1 \ -f:16,8,48000 \ -a:mon1 -o alsa,default I.e. we route the 8ch audio stream to mono chains 1-8, and to 8ch chain labeled 'mon1'. Next we write the mono chains to mono-X.wav files, and output the whole 8ch chain to the alsa output device. As others already noted, you can only connect a chain to one output (same applies for input). I really should add more runtime checks so that ecasound would give a little more informative error messages in these scenarios. -- http://www.eca.cx Audio software for Linux!