[LAU] Audio cutoff when playing using dmix

Hi, I am facing audio clipping issues when dmix is used for playback. For the test we used a full scale sine wave tone generated using software and encoded as "Signed 16 bit Little Endian, Rate 44100 Hz, Mono". The audio is getting cut out at a 2-3 second interval during playback. This happens only for a fraction of second but it is consistent. This does not happen when audio is played back on the device directly but only when going through dmix. We have observed that there were differences in audio cutting off when the sampling rate was set to 8000Hz and 32000 Hz in asound.conf. The contents of asound.conf is pasted below for your reference: pcm.dmixer { type dmix ipc_key 2048 ipc_key_add_uid true slave { pcm hw:0 rate 8000 channels 2 } } pcm.asymed { type asym playback.pcm "dmixer" capture.pcm "hw:0,0" } pcm.rateConvert { type plug slave.pcm "asymed" } The configuration given above works fine with dmix in 2.6.29 kernel, I am using kernel 2.6.22.18. I have compared the configuration differences (buffers and periods) with and without using dmix. I tried applying some parameters (like buffer_size, period_time and period_size) which was in use when audio was played directly to the hardware device by aplay using the following command: aplay -D rateConvert --period-time=92879 --buffer-size=65536 --period-size=4096 /mnt/test.wav -vvv -d 5 There was come improvement in the audio cutting off issue but it was not eliminated completely. Given below are the logs for aplay (-vvv) with and without using dmix (with audio cutoff issue on kernel 2.6.22): Without using dmix: [root@OMAP3 tests]# aplay /mnt/test.wav -vvv -d 5 5 Playing WAVE '/mnt/test.wav' : Signed 16 bit Little Endian, Rate 44100 Hz, Mono Plug PCM: Hardware PCM card 0 'TWL4030' device 0 subdevice 0 Its setup is: stream : PLAYBACK access : RW_INTERLEAVED format : S16_LE subformat : STD channels : 1 rate : 44100 exact rate : 44100 (44100/1) msbits : 16 buffer_size : 65536 period_size : 4096 period_time : 92879 tick_time : 7812 tstamp_mode : NONE period_step : 1 sleep_min : 0 avail_min : 4096 xfer_align : 4096 start_threshold : 65536 stop_threshold : 65536 silence_threshold: 0 silence_size : 0 boundary : 1073741824 Max peak (4096 samples): 0x00006665 ################ 79% Max peak (4096 samples): 0x00006665 ################ 79% ...Same text repeats 50 times... Max peak (4096 samples): 0x00006665 ################ 79% Max peak (4096 samples): 0x00006665 ################ 79% Using dmix: [root@OMAP3 tests]# aplay -D rateConvert /mnt/test.wav -vvv -d 5 Playing WAVE '/mnt/test.wav' : Signed 16 bit Little Endian, Rate 44100 Hz, Mono Plug PCM: Rate conversion PCM (8000, sformat=S16_LE) Its setup is: stream : PLAYBACK access : RW_INTERLEAVED format : S16_LE subformat : STD channels : 1 rate : 44100 exact rate : 44100 (44100/1) msbits : 16 buffer_size : 22050 period_size : 5512 period_time : 125000 tick_time : 0 tstamp_mode : NONE period_step : 1 sleep_min : 0 avail_min : 5512 xfer_align : 5512 start_threshold : 22048 stop_threshold : 22050 silence_threshold: 0 silence_size : 0 boundary : 1445068800 Slave: Route conversion PCM (sformat=S16_LE) Transformation table: 0 <- 0 1 <- 0 Its setup is: stream : PLAYBACK access : MMAP_INTERLEAVED format : S16_LE subformat : STD channels : 1 rate : 8000 exact rate : 8000 (8000/1) msbits : 16 buffer_size : 4000 period_size : 1000 period_time : 125000 tick_time : 0 tstamp_mode : NONE period_step : 1 sleep_min : 0 avail_min : 1000 xfer_align : 1000 start_threshold : 4000 stop_threshold : 4000 silence_threshold: 0 silence_size : 0 boundary : 2097152000 Slave: Direct Stream Mixing PCM Its setup is: stream : PLAYBACK access : MMAP_INTERLEAVED format : S16_LE subformat : STD channels : 2 rate : 8000 exact rate : 8000 (8000/1) msbits : 16 buffer_size : 4000 period_size : 1000 period_time : 125000 tick_time : 0 tstamp_mode : NONE period_step : 1 sleep_min : 0 avail_min : 1000 xfer_align : 1000 start_threshold : 4000 stop_threshold : 4000 silence_threshold: 0 silence_size : 0 boundary : 2097152000 Hardware PCM card 0 'TWL4030' device 0 subdevice 0 Its setup is: stream : PLAYBACK access : MMAP_INTERLEAVED format : S16_LE subformat : STD channels : 2 rate : 8000 exact rate : 8000 (8000/1) msbits : 16 buffer_size : 16000 period_size : 1000 period_time : 125000 tick_time : 7812 tstamp_mode : NONE period_step : 1 sleep_min : 0 avail_min : 1000 xfer_align : 1000 start_threshold : 1 stop_threshold : 2097152000 silence_threshold: 0 silence_size : 2097152000 boundary : 2097152000 Max peak (5512 samples): 0x00006665 ################ 79% Max peak (5512 samples): 0x00006665 ################ 79% ...Same text repeats 36 times... Max peak (5512 samples): 0x00006665 ################ 79% Max peak (5512 samples): 0x00006665 ################ 79% Max peak (5512 samples): 0x00005f1a ############### 74% Please help me fix this issue. Does this occur due to non-optimal settings of the parameters (buffers, periods) in the configuration or is it some other issue with the ALSA library or the kernel? Please ask if any more setup/configuration settings are required for reference. Thanks and Regards, Ruchi Sirauthiya